Turning-technologies Touch Board User Manual download pdf (Page 10)

Touch Board Plus 9

Select eInstruction Device Manager.

The Device Manager window opens.

Select the Touch Board Plus device from the Device Manager window.

Select the Calibrate icon from the toolbar.

The Calibration window opens.

Touch each target as it appears on the board.

TIP

For optimal accuracy, use a Touch Board Plus pen during the calibration process.

NOTE

In addition to the Device Manager calibration, Windows 7 and 8 requires a second calibration when using

the Touch Board Plus independent of WorkSpace. Refer to Calibrating the Touch Board Plus

(Windows 7 and Windows 8) on page 9 for instructions on performing the second calibration.

Calibrating the Touch Board Plus (Windows 7 and Windows 8)

Prerequisites

You must have administrative privileges to perform the Touch Board Plus 16 pt. calibration. After the initial 16 pt. calibration, a

4 pt. calibration can be performed by a non-administrative user. If you do not have administrative privileges, contact your IT

department.

From your computer, right-click the Turning Technologies icon in the

notification area.

Select eInstruction Device Manager.

The Device Manager window opens.

Right/control-click the Touch Board Plus device from the Device Manager window.

Click Touch Settings.

The Tablet PC Settings window opens.

From the Tablet PC Settings window, click Calibrate.

NOTE

If the board has been previously calibrated, click Reset to erase previously stored calibration

data.

Touch each target as it appears on the board.

After the calibration, you must save the calibration data by clicking Yes from your keyboard or mouse.

NOTE

This calibration only needs to be performed once. If the Touch Board Plus and/or projector is moved, you

must perform both calibrations again.

turningtechnologies.com/user-guides

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Turning-technologies Touch Board User Manual Page 10